1.Viscosity (25°C): ~150 – 900 cP
2.Density: ~1.06 – 1.12 g/cm³
3.Hardness (post-cure): ~80–92 Shore D
4.Tensile strength (post-cure): ~40–95 MPa
5.Elongation at break: ~2–8%
6.Printing wavelength / compatibility: 385–405 nm

1.High dimensional accuracy with low linear shrinkage for precise margins and contacts.
2.Good surface finish and detail reproduction for crown & bridge models and provisional restorations.
3.Adequate post-cured strength and hardness for thermoforming, model verification and provisional use.
4.Fast curing and wash/processing workflow compatible with dental production environments.

1.Dental restorative models, crown & bridge dies and study models.
2.Provisional (temporary) crowns and bridges (select biocompatible grades).
3.Thermoforming aligner models and orthodontic models.
4.Dental lab prototypes, surgical guides (use certified biocompatible grades for intraoral use).